Dyson V10, V11 Vacuum Motorhead Brush Bar Assembly 3-Pin (969569-01)

This Product:

• Genuine Dyson V10, V11, SV12, SV14 Brush Bar (Roller Brush) assembly with end cap
• 3-pin roller brush (see notes below for compatibility)
• Brush Width: Approximately 240mm
• Original replacement Dyson part for your V10 cordless vacuum cleaner
• The bristles on the Dyson V10 roller brush are most important to enable a good pick-up on carpet and hard floor. Therefore we recommend to check your roller brush once a year and replace if needed.
• The V10 stickvac brushbar comes off very easily so you will not find it difficult to replace it
• Please ensure that you measure the width of your existing roller brush to ensure this is the correct size for your motorhead
• Alternative for Dyson part number: 972500-01

Special Notes:

• This roller brush has 3 pins as shown in the product images. Some of the older models have a different brush (with 4 pins) and this brush will not fit those motorheads. Please compare your brush with the images on this listing before purchasing. The 4-pin brush is no longer available.
• This roller brush will not fit the wider Dyson V11 Outsize motorheads which use a 305mm wide brush.

This Product Suits:

• Dyson V10 (Model: SV12)
• Dyson V11 (Models: SV14, SV15, SV17, SV28)
• Dyson V12 Detect Slim (Model: SV20)
• Some Dyson Outsize models that use the smaller (less wide) motorhead. This roller brush will not fit the wider Dyson V11 Outsize motorheads which use a 305mm wide brush.

Please Note: This roller brush has 3 pins as shown in the product images. Some of the older models have a different brush (with 4 pins). Please compare your brush with the images on this listing. If your brush looks different please contact us before purchasing it